Page 1 of 1

Native Propel seals

PostPosted:Sun Jun 28, 2020 3:00 pm
by promark03
So I was fortunate to enough to get a damaged propel drive for free. I am in the process of rebuilding it now. I have all of the parts for the rebuild except the o rings.
I know this is a long shot, but does anyone know the O’ring size that seals the bottom unit to the mid section?
They don’t list the oring size in the exploded parts diagram.

Thanks

Re: Native Propel seals

PostPosted:Tue Jun 30, 2020 11:19 am
by Neumie
promark03 wrote:So I was fortunate to enough to get a damaged propel drive for free. I am in the process of rebuilding it now. I have all of the parts for the rebuild except the o rings.
I know this is a long shot, but does anyone know the O’ring size that seals the bottom unit to the mid section?
They don’t list the oring size in the exploded parts diagram.

Thanks

This website seems to have good blow ups: https://thekayakfishingstore.com/catego ... dal-drive/

Re: Native Propel seals

PostPosted:Mon Jul 06, 2020 9:02 am
by promark03
Thanks, for the link. I had looked at those blowup pics of the parts, but it only has the part number. I ended up taking out my bad Oring and measuring it. Looks like it is 45X49X2 mm. I found them pretty cheap on Amazon.