She looked so lonely
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
She looked so lonely
I have been walking by the T-V and she just looks sad, since I built the Northwind she has been replaced for my tripping boat.
This year I am going to do some deer hunting that I need to get to by yak and gar fishing and bowfishing has one draw back out of a yak. (how would you transport a 9 ft fish in a yak)
So out comes the saw and the T-V is under the knife.
More to come later.
Ron
This year I am going to do some deer hunting that I need to get to by yak and gar fishing and bowfishing has one draw back out of a yak. (how would you transport a 9 ft fish in a yak)
So out comes the saw and the T-V is under the knife.
More to come later.
Ron
Re: She looked so lonely
The TV under the knife? Man that Northwind must be one bad arse boat to make you wanna cut up the TV! I will be following along on this one.
HG
HG
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: She looked so lonely
Well the T-V is topless now
Ron
Ron
Re: She looked so lonely
This should be interesting! Dont forget to post pics!
Re: She looked so lonely
Yea..along with a pic. of the fleet you have....Dont forget to post pics!
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: She looked so lonely
My camera died but another one is on the way. I have been working on the T-V decided to take her all the way down to the wood and start over.
This boat has seen some rough usage,been blown down a sand bar for a hundred yards flipping,been dropped of off the top of my jeep,got way over a couple thousand miles under her. She was built from some bad plywood 1/8 inch thick and built with poly ,held up pretty well.
I will try to get some pics posted before long.
Ron
This boat has seen some rough usage,been blown down a sand bar for a hundred yards flipping,been dropped of off the top of my jeep,got way over a couple thousand miles under her. She was built from some bad plywood 1/8 inch thick and built with poly ,held up pretty well.
I will try to get some pics posted before long.
Ron
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: She looked so lonely
Here is what she use to look like.
Took the T-V down to raw wood reapplied cloth. Looking at the bottom after a couple thousand miles of pretty rough treatment I had a good ideal of the wear points. so here is how I did it. put the cloth on in two pieces letting it overlap in the center 3 inches then put a piece of 3 inch tape on top of that. I also put a piece of 3 inch tape on each edge of the hull. After sealing the hull I went back and put on my external stems ,with the hull being separated and sealed and then putting on the stems I never have to worry about water as long as the stems are in place.
A pic of the front stem
Decided to put in pretty long seat rails and a thwart set up for my rods and to brace the hull.
I cut the top off and rebuilt the hull with two short decks and strips on the side.
I used grey rustolem oil base on the inside the hull ,I hope that color will be cool but not so bright it blinds you
I ran out of epoxy so the brite work will get a couple more coats and at least to more graphite coats, it should be a fishing machine
Ron
Took the T-V down to raw wood reapplied cloth. Looking at the bottom after a couple thousand miles of pretty rough treatment I had a good ideal of the wear points. so here is how I did it. put the cloth on in two pieces letting it overlap in the center 3 inches then put a piece of 3 inch tape on top of that. I also put a piece of 3 inch tape on each edge of the hull. After sealing the hull I went back and put on my external stems ,with the hull being separated and sealed and then putting on the stems I never have to worry about water as long as the stems are in place.
A pic of the front stem
Decided to put in pretty long seat rails and a thwart set up for my rods and to brace the hull.
I cut the top off and rebuilt the hull with two short decks and strips on the side.
I used grey rustolem oil base on the inside the hull ,I hope that color will be cool but not so bright it blinds you
I ran out of epoxy so the brite work will get a couple more coats and at least to more graphite coats, it should be a fishing machine
Ron
Re: She looked so lonely
Well I see you opened up the old TV to one huge cockpit....I still use mine and in some of the nastiest ,rockiest ,local river...
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: She looked so lonely
Looks like you and I use the T-V about the same, The big cockpit will let me bring a 9 ft fish out if I ever decide too.
Ron
Ron
Re: She looked so lonely
All that work for a Gater Gar
MM
MM
- bowgarguide
- TKF 5000 Club
- Posts: 5370
- Joined: Mon Jan 15, 2007 7:52 pm
Re: She looked so lonely
MM
Not just any gator gar will get transported in this boat,it will have to be over a 300 lber before I will bring one in, or basically another world record
Ron
Not just any gator gar will get transported in this boat,it will have to be over a 300 lber before I will bring one in, or basically another world record
Ron