fixing wear and tear in polyethylene kayak

Post Reply
User avatar
Crusader
Posts: 613
Joined: Fri Feb 07, 2014 7:28 pm

fixing wear and tear in polyethylene kayak

Post by Crusader »

Guys, is it possible to fix or improve situation on picture below and how? This is the bow of my kayak (Maliby Stealth 14') that spot is so thing now that you press with your finger and it gives way a bit. I call it "some oyster rash"... :)
Last edited by Crusader on Mon May 29, 2017 7:20 pm, edited 1 time in total.
User avatar
Jeaux
Posts: 426
Joined: Sat Jul 17, 2010 9:36 pm
Location: Montgomery TX - Montegut LA

Re: fixing wear and tear in polyethylene kayak

Post by Jeaux »

Were you able to repair?
User avatar
JaimeInTexas
Posts: 588
Joined: Mon Jan 31, 2011 12:59 pm
Location: clear lake

Re: fixing wear and tear in polyethylene kayak

Post by JaimeInTexas »

Put KeelEazy, or equivalent, on the outside.

Edit: skid plate is the term I was trying to remember.

Google: kayak skid plate kit


Edit #2: Might also apply material inside, also, if outside not enough for you peace of mind.
User avatar
Crusader
Posts: 613
Joined: Fri Feb 07, 2014 7:28 pm

Re: fixing wear and tear in polyethylene kayak

Post by Crusader »

Jeaux wrote:Were you able to repair?
I approached it from the different angle -- bought Pescador Sport 12' off craigslist. It is 5 times easier to paddle and has only two parts to deal with -- yak and paddle. It also trivially fits my truck bed. My launch time went down to 5 mins. I am using old yak now only if I take friend with me.

Spoke to Malibu representative -- he suggested to get few sticks of plastic from them and weld them inside and on outside of worn out area. I might do it someday...
User avatar
MobyYack
TKF 1000 Club
TKF 1000 Club
Posts: 1560
Joined: Mon Aug 11, 2014 11:01 am
Location: On the road between Humble & Galveston - Aboard the Pequod - Just below Cpt. Ahab's knee
Contact:

Re: fixing wear and tear in polyethylene kayak

Post by MobyYack »

red hot spackle knife pressing polyethylene against kayak hull
User avatar
kickingback
TKF 5000 Club
TKF 5000 Club
Posts: 5178
Joined: Thu Feb 18, 2016 3:24 pm
Location: Houston, Texas

Re: fixing wear and tear in polyethylene kayak

Post by kickingback »

Watched a video on YouTube of a guy doing this same thing. He used plastic from a milk carton as well and it worked! Take your time if you do weld it to be able to sell it later.
Post Reply