Bent Boat
Posted: Tue Nov 07, 2006 10:33 am
I just found a 2 hole prism for sale but, it is bent.
Any ideas out there on how to unbend a bent boat? A 2 hole Prism that has been hung by the T handles for an undetermined period of time w/out any support in the middle. The bottom of the bow is approximately 4-5" off the ground and the stern only an inch or so when the boat is placed on the ground.
How bad would this compromise the boats handling characteristics, strength, and integrity or would it?
Any ideas or input? Pricing ideas or stay away from it?
Thanks,
Kenny
Any ideas out there on how to unbend a bent boat? A 2 hole Prism that has been hung by the T handles for an undetermined period of time w/out any support in the middle. The bottom of the bow is approximately 4-5" off the ground and the stern only an inch or so when the boat is placed on the ground.
How bad would this compromise the boats handling characteristics, strength, and integrity or would it?
Any ideas or input? Pricing ideas or stay away from it?
Thanks,
Kenny