Sabalo SOT: http://www.jemwatercraft.com/proddetail.php?prod=Sabalo
Aussie built sabalo pic:
![Image](http://i301.photobucket.com/albums/nn80/bemm52/SANY0046.jpg)
I have cut all of the panels and bulkheads and frames and other parts from 4mm 1088 okume ply, and already aligned and glassed the hull panels together. This is an 8 panel hull: 4 bottom panels, 2 sides, and 2 gunwale panels, exluding top decks. A fairly complex build. Panel alignment is pretty key, as you don't want a lot of variation in the shape of the panels over the 15 foot length of the boat so that the hull shape stays true and has proper symmetry.
I'm using US Composites 635 epoxy resin with medium hardener. It isn't quite the same quality as West Marine, but appears to have less amines than West Marine. It's slightly thicker than, but otherwise comparable to System3 epoxy, and quite useable. I'm hoping to get the panels glassed, with a base coat of epoxy, surface sanded and stitched by this weekend so I can start on the stringer system, but that's a lot of work to get done, especially the stitching and alignment.
I'll post up some progress pics when I get a chance.