4 lb anchor
4 lb anchor
I finally got a chance to fish with my new anchor; a 4lb bruce that I got a picture of before the site changed and it worked like a charm for me and my 14ft Aegean kayak. I wraped the anchor twice with 20lb mono to give me a quick release, but it held while I was fishing, just like it was supposed to. Thanks to this board for posting a picture of it so I could make one.
DJ - What is going on out in California
Becareful with too much of a tie down. I had a med tiewrap and pulled a
5/8 cable out of the bottom of a lake.
I use the very small tie wrap and have yet to get it to brake under normal use.
5/8 cable out of the bottom of a lake.
I use the very small tie wrap and have yet to get it to brake under normal use.
Check main page and rigging. There is a px there somewhere
Look on saltwater rigging page or facts.
- harv418
- TKF 2000 club
- Posts: 2024
- Joined: Fri Jun 06, 2003 7:08 am
- Location: Somewhere on the bay in Texas
- Contact:
JimD
Hey Doc Jim. If you are using the smaller wire ties, be sure to kind of HELP them break. Take a razor, or one of those da## drills of yours and make a cut into them. This will lessen the breaking strength of them. Of course, you could just use about 5-6 wraps of Floss.
LOL
Harv
LOL
Harv